Omni Pump International Limited t/a Edincare Pumped Drainage Sys
 01442 211 554
Product Search:   Go

ProTrap Auto 1000 c/w Hot Water Supply

Price: £3,085.00 (£3,702.00 inc. VAT)
Call for availability
12 months

Downloadable Documents
Related products
The ProTrap Auto 1000 AST™ is a fully automatic grease separation and solids removal system suitable for the collection, separation and removal of food waste, fat, oil and grease from grey water before the final discharge.
The system is suitable for installing either at the initial building stage or retro fitting to existing building and can accept waste from sinks, diswashers, combi ovens or similar.
The system consists of a stainless steel tank, food solids collection chamber, FOG container and self cleaning facility.
The system requires the installation of a pre filter, please see 'Related Products' for further information. This model will also require a separate hot water supply and WRAS approved solenoid valve, supplied by others.
Solids Collection
Waste water from the kitchen is directed through the inlet of the ProTrap Auto 1000 AST™ where a removable collection chamber collects any solid debris.
Grease and Oil Separation
Grease in the waste water floats to the surface and is trapped while the clear water leaves the unit and enters the drainage system.
Cleaning and Grease Removal
The ProTrap Auto 1000 AST™ uses a hot water supply agitating the internal of the tank with intermittent
cleaning cycles removing fine sedimentation and back washing the internal filters preventing foul smells. 
Siting the product
The ProTrap Auto 1000 AST™ should be positioned on a firm level surface, resistant to condensation. The unit must be located lower than the outflow of the appliances served so as to provide a gravity fall into the unit.
It is extremely important to site the ProTrap Auto™ with access in mind in the event of maintenance being required.
Inlet connections
The system comes with an inlet connector to accept incoming pipework (inlet size is dependent of size of unit).
Outlet connection
The system comes with a discharge connector that is to be used for connection to your discharge line. The discharge line should be run to the drainage point ensuring that the pipework is run with a fall.
Electrical connection
A qualified person in accordance with the Institute Of
Electrical Engineers Regulations should connect the unit to the appropriate mains supply taking into account all the electrical information provided. IMPORTANT All systems must be used with an appropriate motor rated protection device.
The ProTrap Auto™ requires minimal maintenance. It is advised that the food solids collection chamber and FOG container are emptied and cleaned daily or as and when required. A full service and inspection should be
undertaken twice a year by a service engineer, please contact our service department for further details.
NOTE It is recommended that a
service agreement be taken out with a technically qualified company.
Health & safety
As with all site work, the danger of working with water and electricity can pose a severe threat to health if obvious and fundamental precautions are not taken. Therefore if you are in any doubt regarding the installation, please contact us. All site work must be undertaken by qualified personnel only. These notes are for guidance only and it is for the installer to ensure the installation is in accordance with all structural and regulatory requirements.

Pre Filter

Price: £240.00


Separator for the Pro Trap Auto range

Price: £455.00

Pro Trap Auto Stand - 1000

Price: £205.00