Omni Pump International Limited t/a Edincare Pumped Drainage Sys
 01442 211 554
 
Product Search:   Go

Remota 90


View larger image

Price: £865.00 (£1,038.00 inc. VAT)
1013
2-3 working days
12 months

 
Description
Downloadable Documents
Related products

The Remota 90 is a fully automatic floor mounted pumping station suitable for pumping waste from a complete bathroom to a higher level when gravity drainage is not possible or economical to install.

The system is suitable for installing either at the initial building stage or retro fitting to existing buildings and can accept waste connections from a toilet, basin, shower or bidet.

The system does not need to be connected directly onto the toilet and as so is ideal for remote installation (indoors only) therefore the system can be concealed out of sight. The system is highly reliable and easy to maintain due to its clip on lid.

90 litre storage capacity

Dimensions 

 Model
Length
Width
Height
Remota 90
600mm
400mm
450mm

Specification
 Model
Remota 90
Power Supply
230V AC
Rated Current
1.9A
Motor Rating
250W
Frequency
50Hz
Revolutions per Minute
3000rpm
Max. Vertical Output
8m
Max. Horizontal Output
70m
Horizontal Fall
1:200
Max. Flow Rate
180 l/m
Max. Liquid Temp.
<40°C
Discharge Size
1½''
Cable Length
10m
Weight
15.5kg
Colour
White
Float Level (On)
330mm
Float Level (Off)
125mm

Installation guidelines
It is important to note that these instructions are for guidance only. Please refer to the full Installation and Operating Guidelines when specifying / installing the product.

Siting the Product
The Remota 90 does not need to be connected directly onto the WC pan and so can be sited away from the appliances served. The Remota 90 should be located on a firm level surface lower than the outflow spigot of the WC so as to provide a gravity fall into the unit. It is extremely important to site the Remota 90 with access in mind in the event of maintenance being required.

Inlet connections
The Remota 90 comes complete with 1no. 110mm inlet to accept standard soil pipe and one 32mm inlet to accept 32mm waste pipe.

To connect to the Remota 90 from the WC a 110mm soil pipe must be run with sufficient gradient to gravity drain into the unit and pushed into place using the 110mm rubber connector provided.

To connect additional appliances (i.e. basin, shower, bidet etc.) there is a 32mm inlet on the lid of the Remota 90 or alternatively you can plumb the waste pipe from the appliances directly into the incoming 110mm soil pipe using an appropriate fitting.

Discharge connection
The discharge line should be connected to the tank connector on the side of the unit. The pipework required to connect to the Remota 90 should be 32mm uPVC waste pipe and to connect to the Remota 90 should be 1½" PVC Class E pressure pipe.

All joins in the discharge pipework should be made using solvent cement, under no circumstances should push fit or compression fittings be used.

The Remota 90 is designed for one lift only and the vertical lift should be within 500mm of the unit.

IMPORTANT – It is recommended that there are no bends in the vertical lift, however if this is unavoidable a minimum of slow radius bends may be used.

Electrical connection
A qualified person in accordance with the Institute Of Electrical Engineers Regulations should connect the unit to the appropriate mains supply taking into account all the electrical information provided.

IMPORTANT – All pump systems must be used with an appropriate motor rated protection device.

Maintenance
It is recommended that the Remota 90 be flushed through every two weeks using standard domestic bleaches, WC cleansers, etc.

IMPORTANT – The following items must not be disposed of into the Remota 90:
• Cotton Wool Buds,
• Baby Wipes,
• Any hard objects, i.e. wood, metals, plastics etc.,
• Any fibrous materials such as cloths, rags etc.,
• Or similar.

Health & safety
As with all site work, the danger of working with water and electricity can pose a severe threat to health if obvious and fundamental precautions are not taken. Therefore if you are in any doubt regarding the installation, please contact us.

All site work must be undertaken by qualified personnel only.

These notes are for guidance only and it is for the installer to ensure the installation is in accordance with all structural and regulatory requirements.

Our policy is one of continuous product improvement, we reserve the right to change specifications and prices without prior notice. All information is given in good faith.


AquaSafe Alarm ‘Mini’

Price: £225.00

 

Telemetry System (Hard Wired)

Price: £645.00


Telemetry System (GSM)

Price: £945.00

   
Loading...